PWM Solar Charge Controller, Auto Voltage, 12/24V In 12/24V out, 20A
Tycon Power PMW Solar Charge Controller, Auto Voltage, 12/24V In 12/24V Load Out, 20A.
- 3 Stage PWM Temperature Compensated Charging
- Fully Automatic Operation
- LCD Displays Battery Voltage, Temp, Load Current and Solar Current.
- Autoranging 12V or 24V Battery Arrays
- USB 5V/1A port for emergency mobile device charges
Tycon Systems new TP-SC24-20 solar battery charge controllers are 3 stage PWM type temperature compensated. The solar charge controllers are auto-ranging to accommodate 12V and 24V battery systems. They are designed to charge AGM or GEL type sealed lead acid batteries. They have an integral LCD display that shows battery voltage, temperature, load current and solar current. They have multiple load operating modes which can be set through the “key” button on the controller.
The load output has a soft start feature so it can smoothly and reliably power up high capacitance loads up to 20A. There is a convenient On/Off button to disconnect load power when the unit is operated in the default mode (15).
These PMW solar charge controllers have full electronic protections for short circuit, reverse current, overvoltage, overcharge, over-discharge and over-temperature. The built-in over-discharge protection and low self consumption ensures the battery is not overdischarged, which greatly increases the life of the batteries. All protections are auto-recovery.
The units are protected against lightning strikes with TVS diode protection. They operate over a wide industrial temperature range. Electronics are conformal coated for environmental protection.
An automatic battery equalization charge automatically engages once every 30 days. The equalization charge helps to balance the batteries in an array and reduce the possibility of battery sulfation. The equalization charge is limited to 1- hour duration to preserve battery life.
Connections are via 6 screw terminals for wire size up to 10AWG. There are four screw holes (3.5mm) for mounting. The controllers are internally fused for protection, but we recommend always using an external 20A fuse between the controller and the battery.
We Also Recommend
We Also Recommend
- choosing a selection results in a full page refresh